URC MX-350 Owners Manual - Page 19
BLAST - Setting the Front Panel Blaster On or Off, EMITT - Setting IR Emitter Outputs, The MX-350,
View all URC MX-350 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
The MX-350 4 Select the new setting by pressing the desired button, then press SAVE to save your new setting and return to the RF settings menu. Displays the current ID# Change the ID# to a higher number Change the ID# to a lower number Save the new setting Exit this Menu without changing the IR/RF settings EMITT - Setting IR Emitter Outputs The MRF-250 and MRF-350 Base Stations enable you to route or steer the IR commands from any Device to any or all of the IR Line Outputs. This allows you to control identical devices using the exact same IR commands (such as an array of television sets in a media room or a stack of identical satellite receivers installed in a central location with one satellite receiver dedicated to each room with a television). Each button push (or macro step) is routed to the specific IR Line Output you've assigned to a device. In the factory set default settings, the MX-350 is set to route IR commands from any device to ALL IR Line Outputs simultaneously. To change the MX-350 default settings follow these steps: 1 From the RF Settings Menu, select EMITT. 2 Decide whether you are changing the Emitter settings for all devices or just one of the devices of the MX-350. Select ALL to change the Emitter settings to ALL devices in the MX-350. Then, go to Step 4. Select DEVIC to change the Emitter settings to just one of the devices in the MX-350. Then, go to Step 3. 34 Universal Remote Control, Inc. 3 The display changes to a list of the names of your devices. If you have two pages of devices, pressing either of the page buttons will display the other page. Select the device you would like to change the Emitter settings, then go to Step 4. Page Buttons display the other page of devices. Select a device 4 Select the new setting by pressing the desired button, then press SAVE to save your new setting and return to the RF settings menu. Displays the Line Output # or ALL Change the Line Output upwards Change the Line Output downwards Save the new setting Exit this Menu without changing the EMITT settings BLAST - Setting the Front Panel Blaster On or Off The MRF-250 and MRF-350 Base Stations have a configurable front panel high power IR LED or "blaster" for controlling components in the same cabinet space without emitters attached to their front panel. The front panel blaster can overpower or saturate the sensors of some A/V components, so if intermittent operation occurs, the blaster should be turned off. The blaster is incompatible with a stack of identical components, since all components will receive IR commands at once, no matter what device is selected. Turn off the front panel blaster by following the steps described on the next page: 35