Thermador MEDS301WS Instruction manual - Page 40

Maximum Operating Time Exceeded, Steam Oven Cavity Bulbs

Get Thermador MEDS301WS PDF manuals and user guides View all Thermador MEDS301WS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

Cooling fan runs even when the oven is turned off. This is normal. The cooling fan will continue to run, even after the oven has been turned off, until the oven has cooled sufficiently. Oven door closes faster/slower than normal. The soft-close door hinges contain a damping fluid that is affected by temperature. If the oven is in a cold environment, the door will close slower than it will in a warmer environment. A warmer than normal environment, such as when cooking, may cause the door to close slightly faster. The appliance prompts you to descale without the counter appearing beforehand. The set water hardness range is too low. Check the set water hardness range and adjust if necessary. Carry out descaling. The "Fill water tank" message appears even though the water tank is full. Check that the water tank is fully pushed in to place. The tank could also possibly be damaged from being dropped. Due to impact, components inside the water tank have come loose and the tank is leaking. If the message still appears and neither of these problems are the issue, it may need a new sensor. Call Customer Service. When cooking with steam, a lot of steam is produced. The appliance is being automatically calibrated and is a normal occurance. The appliance cannot be switched on or is on and cannot be operated; the , symbol is shown on the display. The appliance does not heat up; 6 is shown on the display. The panel lock is activated. Press and hold the TIMERS touch button until the , symbol goes away. Demo mode is activated in the basic settings. Turn demo mode to OFF in the settings menu. There is a "pop" noise during cooking. Cold/warm effect with food, caused by the steam. Maximum Operating Time Exceeded Your appliance automatically ends the operation if no duration has been set and the setting has not been changed for 24 hours. The actual cooking time until the operation is stopped automatically varies according to the selected settings. A message appears on the display on the appliance to say that the operation is being ended automatically. Afterwards, the operation is stopped. To use the appliance again, first switch it off. To switch the appliance back on set the required operation. Steam Oven Cavity Bulbs To light the interior of your steam oven cavity, your appliance has one or more long-life LED bulbs. However, if ever an LED bulb or the bulb's glass cover fails, call Customer Service. The lamp cover cannot be removed. 40

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
40
Maximum Operating Time Exceeded
Your appliance automatically ends the operation if no
duration has been set and the setting has not been
changed for 24 hours.
The actual cooking time until the operation is stopped
automatically varies according to the selected settings.
A message appears on the display on the appliance to
say that the operation is being ended automatically.
Afterwards, the operation is stopped.
To use the appliance again, first switch it off. To switch
the appliance back on set the required operation.
Steam Oven Cavity Bulbs
To light the interior of your steam oven cavity, your
appliance has one or more long-life LED bulbs.
However, if ever an LED bulb or the bulb's glass cover
fails, call Customer Service. The lamp cover cannot be
removed.
Cooling fan runs even when the oven is turned off.
This is normal. The cooling fan will continue to run, even after
the oven has been turned off, until the oven has cooled
sufficiently.
Oven door closes faster/slower than normal.
The soft-close door hinges contain a damping fluid that is
affected by temperature. If the oven is in a cold environment,
the door will close slower than it will in a warmer environment.
A warmer than normal environment, such as when cooking,
may cause the door to close slightly faster.
The appliance prompts you to descale without the
counter appearing beforehand.
The set water hardness range is too low. Check the set water
hardness range and adjust if necessary. Carry out descaling.
The “Fill water tank” message appears even though
the water tank is full.
Check that the water tank is fully pushed in to place. The tank
could also possibly be damaged from being dropped. Due to
impact, components inside the water tank have come loose
and the tank is leaking. If the message still appears and
neither of these problems are the issue, it may need a new
sensor. Call Customer Service.
When cooking with steam, a lot of steam is produced.
The appliance is being automatically calibrated and is a
normal occurance.
The appliance cannot be switched on or is on and
cannot be operated; the
‚
symbol is shown on the
display.
The panel lock is activated. Press and hold the TIMERS touch
button until the
‚
symbol goes away.
The appliance does not heat up;
6
is shown on the
display.
Demo mode is activated in the basic settings. Turn demo
mode to OFF in the settings menu.
There is a “pop” noise during cooking.
Cold/warm effect with food, caused by the steam.