Panasonic AJ-PX800G Basic Operating Instructions - Page 114

rr When [USED] is selected Chapter 5 Playback - Thumbnail operations 1 2 5 3 4 Fig. 1 Fig. 2 1 Write-protected mark The mark appears when the P2 card is write-protected. 2 P2 card status (remaining capacity) The remaining memory capacity of the P2 card is shown as a bar graph and percentage. The bar graph indicator moves to the left as the remaining capacity decreases. The following displays may also appear, depending on the card status. [FORMAT ERROR!] [NOT SUPPORTED!] [NO CARD] [AUTH NG CARD] An unformatted P2 card is inserted. An unsupported card is inserted. No P2 card is inserted. Indicates that the card is a microP2 memory card which cannot authenticate a CPS password. Use the cursor buttons to place the cursor on the P2 card for data to be accessed and press the button to display detailed information on the P2 card. Specific information such as the serial number and the user ID can be checked. (Fig. 1) When the maximum number of clips that can be recorded in the P2 card has been reached, [OVER MAX NUMBER CLIPS] is displayed in the P2 card detailed information showing that the upper limit has been reached. 3 Warning card mark When P2 cards are the following status, the mark is displayed. [RUN DOWN CARD] [DIR ENTRY NG] The maximum number of overwrites on the P2 card has been exceeded. The directory structure on the P2 card is not supported. The warning can be checked on the P2 card detailed information in "P2 card status (remaining capacity)" (page 114). (Fig. 2) 4 Total slot memory remaining capacity (or used capacity) This displays the total remaining memory capacity (or used capacity) of the two slots. The available space of a write-protected P2 card is not included in the total available space. 5 P2 card remaining capacity (or used capacity) / total capacity This displays the remaining capacity (or used capacity) / total capacity of the P2 card. Since only the figures in minutes are displayed, the remaining memory capacity (or used capacity) for each P2 card may not match the total capacity. Setting CPS password To set a CPS password, either load the password from the SD memory card or use the menu of the camera to enter the password. Only one CPS password can be set on the camera. Loading the CPS password again overwrites the previously saved password. Loading CPS password from SD memory card 1 Download and install the latest P2 Viewer Plus into a computer. 2 With P2 Viewer Plus, generate a CPS password and write it to the SD memory card. 3 Load the CPS password file. 1) Start the camera, and insert the SD memory card into the SD card slot. - 114 -