LiftMaster CAPXLV2 Installation Manual - English French Spanish - Page 16

INTRODUCTION ACCOUNT SETUP POWER NETWORK/MOUNTING ACCESS CONTROL 1 Connect Internet The CAPXLV2 can connect to the Internet with a wired Ethernet connection or with Wi-Fi® (wireless). Make sure you are in the Admin Mode before you connect to the Internet. If you are not in Admin Mode, press the 3 dots in the upper right corner INTRODoUfCthTeICOANPXLV2 disAplCayCaOndUeNnTterSthEeTAUdPmin CodPeO, eWntEerRthe pasNswEoTrdW(OdeRfaKul/tMisO8U88N8T88IN), Gpress thAeCNCetEwSorSk CtaOb oNnTtRheOL CAPXLV2 display, and press the "Change Network Settings" button. Follow the instructions according to your application. OPTION 1 Wired Connection The Local Area Network (LAN) port is a 10/100 Ethernet interface with an RJ45 jack for connecting the CAPXLV2 to a hub, switch, or router in order for it to gain connectivity to the Internet. Use a straight, (i.e., non-crossover) Cat5e, or Cat6 cable to connect to a local hub, switch or router. This type of cable is referred to as an Ethernet cable in this manual. 1. Plug the input Ethernet cable into the main board. 2. Connect an Ethernet cable from the hub, switch, or router to the LAN port on the main board. When connected properly, the green and amber LED on the Ethernet port of the main board will light/flicker (the main board is located on the back of the CAPXLV2 display). If the green LED is not lit, check the connections on the CAPXLV2 and the Ethernet hub. 3. On the display, select Wired Network if dynamic configuration (DHCP) is desired or select Manual Setup for a static IP address. OPTION 2 Connect through Wi-Fi® (Wireless) 1. On the display select Wi-Fi® Network. 2. Select the network the CAPXLV2 will use. 3. Enter the password for the network. 4. Select Login. Additional compatibility considerations: • When checking signal strength in CAPXLV2 admin mode, at least two bars are recommended. • Use accessory WFBTEXT (WiFi® External Antenna Kit) and WFAEXT (15' WiFi® Extension Kit) to move the CAPXLV2 antenna higher up or to a location resulting in two or more bars. • If using a Wi-Fi® signal strength tool or app, a continuous Wi-Fi® signal strength connection of at least -65 DBM (numbers closer to zero are stronger strength) at the CAPXLV2 must be guaranteed to ensure an acceptable connection to the local network. • Hidden network SSID's are not supported. The network must be selectable from the CAPXLV2 display. • Wi-Fi® networks requiring secondary authentication are not supported (E.g. Hotels and airport Wi-Fi®). 2 Validate Setup On the display, select each tab in Admin Mode to validate setup (network, inputs, outputs, etc.). Once you have validated the setup, exit Admin Mode. 16