LiftMaster CAPXLV2 Installation Manual - English French Spanish - Page 11
POWER, 1. Remove Knockouts, Electrical Wiring
View all LiftMaster CAPXLV2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
INTRODUCTION ACCOUNT SETUP POWER NETWORK/MOUNTING ACCESS CONTROL 1 Remove Knockouts INTROD1U. CTTuIrOnNthe key cloAcCkwCiOseUtoNuTnlSocEkTthUePCAPXLVP2O. WER To pNreEveTnWt dOamRaKg/eMtoOtUheNCTAIPNXGLV2 froAmCmCoEisStuSreCoOr wNaTteRr:OL 2. Open the door and lay the CAPXLV2 face down on a table with the door hanging off the edge of the • DO NOT install during rain. Internal components MUST be kept free from of water and moisture. table as shown. • BEFORE opening the front cover of the CAPXLV2, remove ANY accumulated water from the top of the CAPXLV2. 3. Identify which knockouts need to be removed To prevent damage to ANY internal components: based on your application. • DO NOT attempt to remove the knockouts with a hammer. INTROD4U. CTUsIOe aNcenter puAnCchCtOooUl tNoTremSEovTeUthPe knockPoOutWs ER from the outside of the box inward using an appropriately sized punch and hammer. BanNgEinTgWonOtRheKk/nMoOckUouNtsTmINayGresultAinCsChEocSkStoCthOeNciTrcRuOit L boards, which could cause permanent damage. • Some internal wires may be close to the knockouts. Make sure to move any wire away from knockouts. NOTE: Be careful when removing the knockouts to avoid damaging the CAPXLV2 components. R R W WS P P E P P R R E = Electrical Wiring P = Pedestal Mount R = Recess Mount S = Radio Antenna W = Wi-Fi® Antenna 11