AEG AXP26U558HW User Manual - Page 21
Trouble Shooting - review
View all AEG AXP26U558HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
ENGLISH 21 2. Wash the filter using liquid dishwashing detergent and warm water under 40°C. Rinse filter thoroughly. Gently shake excess water from the filter. Be sure filter is thoroughly dry before replacing. Or, instead of washing you may vacuum the filter clean. 3. Replace the filter after the filter is dry. Be sure filter is thoroughly dry before replacing. 8.3 Winter Storage If the air conditioner will not be used for an extended period of time: 1. Drain the water collection tank completely and leave the bottom drain cap and rubber plug long time enough to allow any residual water to drain out. Once the tank is completely drained and no more water flows out, reinstall the rubber plug and cap. 2. Remove and clean the filter, allow it to dry completely, then reinstall it. 3. Remove the batteries from the remote control. 4. Store the air conditioner in a cool, dry location, away from direct sunlight, extreme temperature, excessive dust, and well ventilated. Before using the air conditioner again: 1. Make sure the filter and drain cap are in place. 2. Check the cord to make sure it is in good condition, without cracks or damage. 3. Place new batteries in the remote control. 4. Install the air conditioner as described in the Installation Instructions. 9. TROUBLE SHOOTING Before calling for service, review this list. It may save you time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Air conditioner will not operate. • Wall plug disconnected. Push plug firmly into wall outlet. • House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker. • Control is OFF. Turn Control ON and set to desired setting. • Fault code P1 appears in the display window. Drain water as described in 7.3 Drainage Section. • Room Temperature lower than the set temperature (Cool Mode) or Room Temperature higher than the set temperature (Heat Mode). Reset the temperature. Air from unit does not feel cold enough. • Room temperature below 16°C. Cooling may not occur until room temperature rises above 16°C. • Reset to a lower temperature. • Compressor shut-off by changing modes. Wait approximately 4 minutes and listen for compressor to restart when set in the COOL mode. Air conditioner cooling, but room is too warm - NO ice forming on cooling coil behind decorative front. • Outdoor temperature below 16°C. To defrost the coil, set Fan mode. • Air filter may be dirty. Clean filter. Refer to 8. Care and Cleaning section. To defrost, set to Fan mode. • Temperature is set too low for nighttime cooling. To defrost the coil, set to Fan mode. Then, set temperature to a higher setting. • Exhaust duct not connected or blocked. See 5.1 Exhausting hot air Section.