2010 Yamaha Motorsports Phazer R-TX Owners Manual - Page 70
2010 Yamaha Motorsports Phazer R-TX Manual
Page 70 highlights
Periodic maintenance and adjustment 5. Install the dipstick, making sure to align the notch in the dipstick handle with the projection on the drive chain housing. 2 1 1. Notch 2. Projection 1. Locknut 2. Chain tension adjusting bolt 5. Install the right side cover. ESU13431 Brake and parking brake EWS00440 Install the right side cover. Release the parking brake. Drive the snowmobile for several minutes at more than 20 km/h (12 mi/h), and then repeat steps 1-7 to check the oil level again. To adjust the chain tension 1. Remove the right side cover. (See page 48 for removal procedures.) 2. Loosen the locknut. 3. Turn the chain tension adjusting bolt clockwise until it is finger tight, and then loosen it 1/4 turn. 4. While holding the chain tension adjusting bolt with a wrench, tighten the locknut to the specified torque. Tightening torque: Locknut: 25 Nm (2.5 m·kgf, 18 ft·lbf) 6. 7. 8. WARNING G G A soft, spongy feeling in the brake lever indicates a failure in the brake system. Do not operate the snowmobile if you find any problems in the brake system. You could lose braking ability, which could lead to an accident. Ask a Yamaha dealer to inspect and repair the brake system. ECS00060 NOTICE Make sure that the brake lever end does not project out over the handlebar end. This will help prevent brake lever damage when the snowmobile is placed on its side for service. Test the brake at a low speed when starting out to make sure that it is working properly. If the brake does not provide proper braking performance, inspect the brake for wear or brake fluid leakage. (See the following section for more details.) Checking the brake pads Check the brake pads for wear according to the following procedure. 64