2010 Yamaha Motorsports Apex LTX GT Owners Manual - Page 58

2010 Yamaha Motorsports Apex LTX GT Manual

Get 2010 Yamaha Motorsports Apex LTX GT PDF manuals and user guides View all 2010 Yamaha Motorsports Apex LTX GT manuals

Page 58 highlights

Periodic maintenance and adjustment 1. Oil level gauge coupler 2. Oil filler cap 1. "H" level mark 2. "L" level mark 5. Remove the oil filler cap, wipe the dipstick clean, insert it back into the oil filler hole (without screwing it in), and then remove it again to check the oil level. 6. 1. Oil filler cap 2. Dipstick If the engine oil is below the "L" level mark, add sufficient oil of the recommended type to raise it to the "H" level mark. (See page 80 for the recommended oil.) NOTICE: When adding the engine oil, be careful not to fill above the "H" level mark on the dipstick. Use only the recommended oil. (See page 80.) Make sure that no foreign material enters the engine oil tank. [ECS00462] 7. Insert the dipstick into the oil filler hole, and then tighten the oil filler cap. 8. Connect the oil level gauge coupler. 9. Install the right side cover and the shroud. To change the engine oil (without oil filter cartridge replacement) TIP The engine oil should be between the "H" and "L" level marks on the dipstick. TIP Have a Yamaha dealer replace the oil filter cartridge. 1. 2. 3. Place the snowmobile on a level surface and apply the parking brake. Start the engine, warm it up for several minutes, and then turn it off. Remove the shroud and the right side cover. (See page 43 for removal procedures.) Remove the bottom panel and the right lower cover. 4. 52

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
Periodic maintenance and adjustment
52
5.
Remove the oil filler cap, wipe the dipstick
clean, insert it back into the oil filler hole
(without screwing it in), and then remove
it again to check the oil level.
TIP
The engine oil should be between the “H” and
“L” level marks on the dipstick.
6.
If the engine oil is below the “L” level
mark, add sufficient oil of the recom-
mended type to raise it to the “H” level
mark. (See page 80 for the recommend-
ed oil.)
NOTICE:
When adding the en-
gine oil, be careful not to fill above the
“H” level mark on the dipstick. Use
only the recommended oil. (See page
80.) Make sure that no foreign material
enters the engine oil tank.
[ECS00462]
7.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8.
Connect the oil level gauge coupler.
9.
Install the right side cover and the shroud.
To change the engine oil (without oil filter car-
tridge replacement)
TIP
Have a Yamaha dealer replace the oil filter
cartridge.
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Start the engine, warm it up for several
minutes, and then turn it off.
3.
Remove the shroud and the right side
cover. (See page 43 for removal proce-
dures.)
4.
Remove the bottom panel and the right
lower cover.
1.
Oil level gauge coupler
2.
Oil filler cap
1.
Oil filler cap
2. Dipstick
1.
“H” level mark
2.
“L” level mark