2008 Yamaha Motorsports Phazer GT Owners Manual - Page 59

2008 Yamaha Motorsports Phazer GT Manual

Get 2008 Yamaha Motorsports Phazer GT PDF manuals and user guides View all 2008 Yamaha Motorsports Phazer GT manuals

Page 59 highlights

Periodic maintenance 5. Remove the oil filler cap, wipe the dipstick clean, insert it back into the oil filler hole (without screwing it in), and then remove it again to check the oil level. 2. Start the engine, warm it up for 10-15 minutes, and then turn it off. The engine can also be warmed up by operating the snowmobile for 10-15 minutes. After operating the snowmobile, allow the engine to idle for at least 10 seconds before turning it off. Remove the right side cover (PZ50RT / PZ50GT / PZ50MT), or open the shroud and remove the right upper cover and the right side cover (PZ50VT). (See page 45 for removal procedures.) Disconnect the oil level gauge coupler. NOTE: G 1. Oil filler cap 2. Dipstick G NOTE: The engine oil should be between the "H" and "L" level marks on the dipstick. 3. 4. 1. "H" level mark 2. "L" level mark 6. 1. Oil level gauge coupler 2. Oil filler cap ECS00451 If the engine oil is below the "L" level mark, add sufficient oil of the recommended type to raise it to the "H" level mark. (See page 76 for the recommended oil.) ECS00461 CAUTION: Disconnect the oil level gauge coupler before removing the oil filler cap, otherwise the cable could twist and break. CAUTION: G When adding the engine oil, be careful not to fill above the "H" level mark on the dipstick. 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
Periodic maintenance
53
2.
Start the engine, warm it up for 10–15
minutes, and then turn it off.
NOTE:
●
The engine can also be warmed up by op-
erating the snowmobile for 10–15 minutes.
●
After operating the snowmobile, allow the
engine to idle for at least 10 seconds before
turning it off.
3.
Remove the right side cover (PZ50RT /
PZ50GT / PZ50MT), or open the shroud
and remove the right upper cover and the
right side cover (PZ50VT). (See page 45
for removal procedures.)
4.
Disconnect the oil level gauge coupler.
CAUTION:
ECS00451
Disconnect the oil level gauge coupler be-
fore removing the oil filler cap, otherwise
the cable could twist and break.
5.
Remove the oil filler cap, wipe the dipstick
clean, insert it back into the oil filler hole
(without screwing it in), and then remove
it again to check the oil level.
NOTE:
The engine oil should be between the “H” and
“L” level marks on the dipstick.
6.
If the engine oil is below the “L” level
mark, add sufficient oil of the recom-
mended type to raise it to the “H” level
mark. (See page 76 for the recommend-
ed oil.)
CAUTION:
ECS00461
●
When adding the engine oil, be careful
not to fill above the “H” level mark on the
dipstick.
1.
Oil level gauge coupler
2.
Oil filler cap
1.
Oil filler cap
2. Dipstick
1.
“H” level mark
2.
“L” level mark