2008 Yamaha Motorsports Phazer GT Owners Manual - Page 23
2008 Yamaha Motorsports Phazer GT Manual
Page 23 highlights
Control functions ESU10661 Headlight beam switch "LIGHTS" Push the headlight beam switch to change the headlight to high beam "HI" or to low beam "LO". To lower the temperature Continue to press the switch until the temperature level returns to the minimum level, and then raise the temperature to the desired level. ESU10690 Auxiliary DC jack (PZ50VT) The auxiliary DC jack is located in the front panel and can be used for accessories. NOTE: The auxiliary DC jack cannot be used if the engine is not running. To use the auxiliary DC jack 1. Start the engine. 2. Open the auxiliary DC jack cap, and then insert the accessory power plug into the jack. 1. Headlight beam switch "LIGHTS" 2. High beam "HI" 3. Low beam "LO" ESU10670 Grip/thumb warmer adjustment switch The grip/thumb warmer adjustment switch controls the electrically heated handlebar grips and throttle lever. 1. Auxiliary DC jack cap 2. Auxiliary DC jack NOTE: After using the auxiliary DC jack, be sure to remove the accessory power plug from the jack and close the auxiliary DC jack cap. 1. Grip/thumb warmer adjustment switch ECS00120 To raise the temperature To raise the grip warmer temperature, press the " " side of the switch. To raise the thumb warmer temperature, press the " " side of the switch. CAUTION: G Do not use accessories requiring more than the maximum rated capacity for the auxiliary DC jack. This may overload the circuit and cause the fuse to blow. (See page 69 for the specified amperage.) 17