2010 Mercedes ML-Class Owner's Manual - Page 201
2010 Mercedes ML-Class Manual
Page 201 highlights
Useful features X RThe 199 Start the engine. temperature of the DC/AC inverter is temporarily too high. X Pull the plug of the small device out of 115V AC socket : and plug it in again after waiting a few minutes. small devices have a continuous power rating of less than 150 W but a very high switch-on current. Such devices will not operate. When connecting such a device, 115V AC socket : will not provide power. monitoring services, connection and cellular air time Rvehicle Rthe battery power is available i Location of the vehicle on a map is only possible if the vehicle is able to receive signals from the GPS satellite network and pass the information on to the Customer Assistance Center. The Tele Aid system (Telematic Alarm Identification on Demand) The Tele Aid system consists of three types of response: RAutomatic RRoadside If LED ; still does not come on, contact an authorized Mercedes-Benz Center. Tele Aid ! In order to activate the Tele Aid system, a subscriber agreement must be completed. To ensure your system is activated and operational, please press Information button E to perform the acquaintance call. Failure to complete either of these steps may result in a system that is not activated. If you have any questions regarding activation, please call the Customer Assistance Center at 1-800-FOR-MERCedes (1-800-367-6372) (USA only) or 1-888-923-8367 (Canada only). Shortly after the completion of your Tele Aid acquaintance call, you will receive a user ID and password in the mail. You may use this password to access the Tele Aid section in "Owner's Online" at www.mbusa.com (USA only). The "My Tele Aid" section will give you access to account information, remote door unlock and more. The Tele Aid system is available if Rit has been activated and is operational. Activation requires a subscription for and manual emergency Assistance RInformation To adjust the speaker volume during a Tele Aid call do the following: X Press button W or X on the multifunction steering wheel. or X Use the adjustment button on your COMAND system. Be sure to check "Owner's Online" at www.mbusa.com (USA only) for more information and a description of all available features. System self-test The system performs a self-test after you have switched on the ignition. G Warning! A malfunction in the system has been detected if any or all of the following conditions occur: Z Controls in detail RSome relevant cellular phone network and GPS signals are available and pass the information on to the Customer Assistance Center