2010 Mercedes GL-Class Owner's Manual - Page 343
2010 Mercedes GL-Class Manual
Page 343 highlights
Flat tire Lifting the vehicle G Warning! When jacking up the vehicle, only use the jack which has been specifically approved by Mercedes-Benz for your vehicle. The jack is designed exclusively for jacking up the vehicle at the jack take-up brackets built into both sides of the vehicle. Make sure the jack arm is fully seated in the jack take-up bracket. The jack must always be vertical when in use, especially on inclines or declines. The jack is intended only for lifting the vehicle briefly for wheel changes. It is not suited for performing maintenance work under the vehicle. To help avoid personal injury, use the jack only to lift the vehicle during a wheel change. Never get beneath the vehicle while it is supported by the jack. Keep hands and feet away from the area under the lifted vehicle. Always lower the vehicle onto sufficient capacity jackstands before working under the vehicle. Always engage the parking brake firmly and block the wheels with wheel chocks or other sizeable objects before raising the vehicle with the jack. Do not disengage the parking brake while the vehicle is raised. Make sure that the ground on which the vehicle is standing and where you place the jack is solid, level and not slippery. If necessary, use a large underlay. On slippery surfaces, such as tiled floors, you should use a non-slip underlay, for example a rubber mat. Do not use wooden blocks or similar objects to support the jack. Otherwise the jack may not be able to achieve its load-bearing capacity if it is not at its full height. Never start the engine when the vehicle is raised. Also observe the notes on the jack. X 341 Prevent the vehicle from rolling away by blocking wheels with wheel chocks or other sizeable objects. When your vehicle is equipped with a wheel chock, it is included with the vehicle tool kit (Y page 284). For information on setting up the collapsible wheel chock, see (Y page 286). G Warning! Changing a wheel on a level surface Changing rear wheel on passenger side (example illustration) X Place a wheel chock or other sizeable object in front of and another wheel chock or other sizeable object behind the wheel that is diagonally opposite to the wheel being changed. Changing a wheel on a slight decline Always try lifting the vehicle using the jack on a level surface. However, should circumstances require you to do so on a slight decline: Z Practical hints Only jack up the vehicle on level ground or on slight inclines/declines. Otherwise, the vehicle could fall off the jack and injure you or others.