2003 Ducati SuperSport 800 SS Owners Manual - Page 101
2003 Ducati SuperSport 800 SS Manual
Page 101 highlights
Setting the gear change and rear brake pedals The gear change and rear brake pedals can be adjusted to suit the preferred riding position of each rider. To set the gear change pedal, lock linkage (1) and loosen the check nuts (2) and (3). Note Nut (2) has a left-hand thread. Fit an open-end wrench to the hexagon portion of linkage (1). Rotate linkage until setting pedal in the desired position. Tighten both check nuts onto linkage. To set the rear brake pedal, loosen check nut (4). Turn pedal travel adjusting screw (5) until pedal is in the desired position. Tighten check nut (4). Work pedal by hand to make sure it has 1.5 - 2 mm free play before brake begins to bite. If not so, set the length of cylinder linkage as follows. Loosen the check nut (6) on cylinder linkage. Tighten linkage into fork (7) to increase play, or unscrew linkage to reduce it. Tighten check nut (6) and check pedal free play again. E fig. 18 6 7 5 4 fig. 19 25