Icom IC-T10 Advanced Manual - Page 31
Voltage indication, Auto low power, Tone burst, Earphone antenna, Monitor, Default: OFF
View all Icom IC-T10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
5 SET MODE Initial Set Mode items Voltage indication (Default: On) Earphone antenna (Default: OFF) Selects whether or not to display the battery voltage while turning ON the transceiver. ••OFF: The transceiver does not display the battery voltage. ••On: The transceiver displays the battery voltage. Auto low power (Default: OFF) Selects whether or not to use the earphone antenna for FM radio. ••OFF: An earphone antenna is not used. ••On: An earphone antenna is used. Monitor (Default: PUSH) Selects whether or not to enable the Auto Low Power function. ••OFF: Turns OFF the function. ••On: When the temperature goes below 0˚C (32˚F), the transceiver automatically sets the all output power to low. LLHigh or Mid power are disabled. Tone burst (Default: OFF) Selects how to use the Monitor function. ••PUSH: Hold down [MONI] to monitor the frequency. Release to stop monitoring. ••HOLd: Push [MONI] momentarily to monitor the frequency and push momentarily again to cancel it. Selects whether or not to enable the Tone Burst function when using the Tone Squelch function. ••OFF: When you transmit a signal that superimposes the CTCSS tone, the other stations may hear a short burst of noise from their receiver, just after you stop transmitting. ••On: When you transmit a signal that superimposes the CTCSS tone, the function mutes the noise from being heard in the other station receiver. 5-9