Icom IC-T10 Advanced Manual - Page 16

3 SCAN OPERATION VFO Scan The VFO scan searches for signals within the specified frequency range. 1. Repeatedly push [V/M/C] to select the VFO mode. 2. H old down [SCAN] until a beep sounds to start the scan. LLWhile scanning, repeatedly push [SET] to select a scan type. Full scan Band scan DDVFO Scan type There are the following types of VFO scans. ALL: Full scan bAnd: Band scan PROG1 ~ 3: Program scan TIP: About the Band scan While scanning the VHF or UHF band, push [BAND] to switch the scan to the other band. LLWhile scanning the FM radio band, you cannot switch to VHF or UHF. DDUsing the Program Skip function You can skip unnecessary frequencies during a scan. Enter the Skip Channel in Memory mode to use the function. LLThe skipped frequencies will be scanned if the Program Skip function is turned OFF in the Set mode (p. 5-4). Program scan LLWhile scanning, the scan type in progress is indicated by two letters. LLWhile scanning, push [BAND] to change the band to scan, or scope of the Program Scan. LLWhile receiving a signal, the S-meter displays the received signal strength. 3. Push [SCAN] or [V/M/C] to cancel the scan. TIP: ••While scanning, rotate [DIAL] to change the scanning direction. ••While scanning, hold down [ ] to turn the Lock function ON or OFF. 3-4