Icom IC-T10 Advanced Manual - Page 22

4 REPEATER AND DUPLEX OPERATION Duplex operation DDUsing the Duplex Reverse function When the Duplex Reverse function is ON, the receive and transmit frequencies are reversed. 1. Push [SET] to enter the Set mode. ••A Set mode item is displayed. 2. Repeatedly push [SET] to select "dUP.REV." 3. Rotate [DIAL] to select "On." DDUsing the Auto Repeater function (For only the USA version) When the operating frequency falls within the Repeater output frequency range, the Auto Repeater function automatically sets the Repeater settings (Duplex ON/OFF, Duplex direction, Tone encoder ON/ OFF). 1. Rotate [VOL] counter-clockwise to turn OFF the transceiver. 2. While holding down [SET], rotate [VOL] clockwise to turn ON the transceiver. ••An Initial Set mode item is displayed. 3. Repeatedly push [SET] to select "AutoRP." 4. Push [V/M/C] to exit the Set mode. ••"DUP" blinks while operating. Example: Offset: 5.000 MHz Duplex direction: DUP- Duplex Reverse OFF On Receive 149.900 MHz 144.900 MHz Transmit 144.900 MHz 149.900 MHz 4. Rotate [DIAL] to select an option. 5. Push [V/M/C] or [ENT] to exit the Initial Set mode. Frequency range and offset direction: Frequency range 145.200 ~ 145.495 MHz 146.610 ~ 146.995 MHz 147.000 ~ 147.395 MHz 442.000 ~ 444.995 MHz 447.000 ~ 449.995 MHz Shift direction DUP- DUP- DUP+ DUP+ DUP- DDOff band indication If the transmit frequency is out of the amateur band, the off-band indication, "OFF" is displayed when you push [PTT]. Check the frequency offset or duplex direction in this case. While accessing a repeater While transmitting in Duplex mode 4-5