BenQ W1110 User Manual - Page 52
Indicators
View all BenQ W1110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
15. Connect the power and restart the projector. 16. After the startup logo displays, reset the lamp timer via the OSD menu. • Under the Advanced OSD menu, go to System Setup : Advanced > Lamp Settings > Reset Lamp Timer, and select Reset. • Under the Basic OSD menu, if there's no signal connected to the projector, go to Reset Lamp Timer and select Reset; if there are signals connected, go to Settings > Reset Lamp Timer, and select Reset. Do not reset if the lamp is not new or replaced as this could cause damage. A "Reset Successfully" message displays to notify that the lamp time has been reset to "0". Indicators There are three indicators which show the status of the projector. Check the following information about the indicator lights. If there is anything wrong, turn the projector off and contact your dealer. Light Status & Description Orange Green Flashing Green Orange Flashing Red Green Red Green Green Off Off Red Red Red Red Off Off Off Off Red Off Off Off Green Off Off Red Red Flashing Green Green Flashing Off Off Off Off Red Red Red Off Green Red Orange Flashing Off Off Off Off Power events Stand-by mode Powering up Normal operation Normal power-down cooling Downloading CW start fail Scaler reset fail Burn-in ON Burn-in OFF Lamp events Lamp1 error in normal operation Lamp is not lit up Thermal events Fan 1 error (the actual fan speed is ±25% outside the desired speed) Fan 2 error (the actual fan speed is ±25% outside the desired speed) Fan 3 error (the actual fan speed is ±25% outside the desired speed) Fan 4 error (the actual fan speed is ±25% outside the desired speed) 52 Maintenance