2012 Yamaha Motorsports Phazer R-TX Owners Manual - Page 64
2012 Yamaha Motorsports Phazer R-TX Manual
Page 64 highlights
Periodic maintenance and adjustment 5. Remove the oil filler cap, wipe the dipstick clean, insert it back into the oil filler hole (without screwing it in), and then remove it again to check the oil level. 2. Start the engine, warm it up for 10-15 minutes, and then turn it off. The engine can also be warmed up by driving the snowmobile for 10-15 minutes. After driving the snowmobile, allow the engine to idle for at least 10 seconds before turning it off. Remove the right side cover (PZ50RT / PZ50GT / PZ50MT), or open the shroud and remove the right upper cover and the right side cover (PZ50VT). (See page 49 for the procedures.) Disconnect the oil level gauge coupler. NOTICE: Disconnect the oil level gauge coupler before removing the oil filler cap, otherwise the cable could twist and break. [ECS00452] 1. "H" level mark 2. "L" level mark TIP G 1. Oil filler cap 2. Dipstick G TIP The engine oil should be between the "H" and "L" level marks on the dipstick. 3. 4. 6. 1. Oil level gauge coupler 2. Oil filler cap If the engine oil is below the "L" level mark, add sufficient oil of the recommended type to raise it to the "H" level mark. (See page 83 for the recommended oil.) NOTICE: When adding the engine oil, be careful not to fill above the "H" level mark on the dipstick. Use only the recommended oil. (See page 83.) Make sure that no foreign material enters the engine oil tank. [ECS00462] 58