1997 Oldsmobile Bravada Owner's Manual - Page 252
1997 Oldsmobile Bravada Manual
Page 252 highlights
Center High-Mounted Stoplamp 1. Remove the two screws. 2. Pull the lamp assembly out. 3. Turn the socket counterclockwise and pull it out. 4. Holding the base of the bulb, pull the bulb straight out of the socket. 4. Turn the socket counterclockwise to remove it. Push the tab in while you turn the socket counterclockwise. 5 . Holding the base of the bulb, pull the bulb straight out of the socket. 6. Push the new bulb straight into the socket until it clicks. 7. Put the socket into the lamp assembly and turn the socket clockwise until it locks into place. 8. Install the lamp assembly and screws. 9. Close the endgate. 5. Reverse the steps to install a new bulb. Taillamps 1. Open the endgate. 2. Remove the two screws from the lamp assembly. Underhood Lamp 1. Disconnect the electrical connector from the underhood lamp assembly. 2. Remove the screws. 3. Disconnect the ground wire. 4. Remove the lamp assembly from the hood. 5 . Install the new bulb. 6. Replace the assembly. Install and tighten the screws. 7. Connect the ground wire. 3. Pull the assembly away from the vehicle. 8. Connect the electrical connector to the lamp assembly. 6-32