1994 Oldsmobile Achieva Owner's Manual - Page 121
1994 Oldsmobile Achieva Manual
Page 121 highlights
NEXT: Press to advance to the next track. If you keep pressing the NEXT button, thedisc will keep advancingto other tracks. When Finished with the Compact Disc Player: If you use the PWR-VOL knob to turn off the power, or turnoff the ignition, the disc will stay in the player and start again when you turn on theignition or the PWR-VOL knob. The disc will begin playing at thepoint where it had been stopped. ST-PL (Stop-Play): Press to stop the disc player; the radio will play. Press again to play the disc (the player will start playing the disc whereit had stopped earlier). EJCT (Eject): Press to eject the disc; the radio will play. You can also eject the disc with the radio or ignition off. CD Player Anti-Theft Feature Delco LOC 110 is an anti-theft feature for the compact disc player. It can be used or ignored. If ignored, the system plays normally. If it is used,your player won't be usable if it is ever stolen, because it will go to LOC mode any time battery power is removed. It will also go to LOC mode any time power from the battery is turned off by the Battery Rundown Protection feature (see the Index under Battery Rundown Protection). Until an unLOC code is entered, it will not turn on. The instructionsbelow tell you how to enter a secret code into the system. If your vehicle loses battery power for any reason, you must unlock the system with the secret code before your audio system will turn on. To Set the Anti-Theft System: 1. Write down any six-digit number and keep it in a safe place. This is your secret code. 2. Turn the ignition to theAccessory or Run position. 3.Rotate the PWR-VOL knob to turn the radio off. 4. Press station preset buttons 1 and 4 at the same time and hold until "---" shows on the display. You now have only 15 seconds between each of the following steps. 5. Press SET, and 000 will appear on the display. 6. Press SCAN until the first digit of your code appears. 7. Press SEEK until the second and third digits of your code appear. 8. Press the TUNE knob (000 will appear again on the display). 9. Press SCAN until the fourth digit of your code appears. IO. Press SEEK until the fifth and sixth digits of your code appear. 11. Press the TUNE knob (rEP will appear for five seconds, then 000 ) . 12. Repeat steps 6 through 10. Then press the TUNE knob again. SEC will appear, indicating that Delco LOC 110 is set, and your audio system is secure. If "---" appears, the steps were not successful and you must repeat the entire procedure. 119