Xerox 490ST System Administration Guide - Page 71

9.9.MMiiccrroosofftt((TTCCP/PI/IP)P) NNeettwwoorrksks Go to the Document Centre and... NOTE This procedure assumes that any TCP/IP components necessary for network installation have already been assigned to the Document Centre. If these components have not been configured, please refer to the appropriate information contained within the section entitled Dynamic/Static IP Addresses & WINS before continuing further. Connect your Document Centre to the network with the appropriate cabling. 1. Enter the Tools pathway. a) Press the Access ( or ) button. b) On the keypad enter 1111 or the current password. Press the Enter button when finished. The Touch Screen will be used for the remainder of the data entry, unless instructed otherwise. c) Press the Go to Tools button. 2. Enter the Network Setup menus. a) Wait for the screen to refresh and press the Connectivity and Network Setup button. b) Wait for the screen to refresh and press the Network Setup button. 3. Enable Microsoft Networking. a) Press the Microsoft Networks button. b) At the next screen, press the Transport and Media button. c) Press the Enable button to enable the Microsoft Network protocols. d) If Physical Media buttons appear, press the corresponding button to select either IP/Ethernet, or IP/Token Ring. After making your selection press Save. e) Press the Workgroup and Host button. Xerox Document Centre System Administration Guide Page 9 - 3