Xerox 490ST System Administration Guide - Page 38

Windows Internet Name Service (WINS) Installation NOTE Before You Start If your printer is equipped with a Token Ring interface, use the 100BaseT Ethernet or Token Ring Quick Install Card supplied in this Quick Install Card set to configure the Ring Speed and Source Routing settings for your environment. Your Document Centre now has DHCP, LPR, and NetBIOS over the IP protocol enabled by default. If your DHCP server will provide the IP address, Gateway address, Subnet Mask for the Document Centre, and WINS server address(es), the TCP/IP information will be configured on initial boot. This means that if you have configured your DHCP server with the desired information, you may connect your Document Centre to your network and it will boot and register with the WINS server automatically. Your DHCP server must return at least one (1) WINS server address to the Document Centre in order to enables WINS registration. In this mode the default NetBIOS host name, SMB host name and the DNS host name for the device will be the letters XRX followed by the MAC address of the network interface. Example: XRX08003E313E0A If this NetBIOS host name is acceptable you can go right to the section in the next section entitled Go to the Workstation and.... and complete those steps. To change the NetBIOS host name for your printer follow Steps 1, 2, and 3 then skip to Step 5 and finish the Go to the Document Centre... portion. When you finish that section, go to the section entitled Go to the Workstation and.... and complete those steps. Page 3 - 10 Xerox Document Centre System Administration Guide