Tanaka TCG24ECPSL Manual - Page 9
Operating Procedures
View all Tanaka TCG24ECPSL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
5 6 English Fig. 3 Fig. 5 Also, you can extend the nylon line by hand but the engine must be completely stopped. (Fig. 6) ○ The cutting head must be securely mounted to the unit's gear case. ○ If the cutting head does not feed cutting line properly, check that the nylon line and all components are properly installed. Contact Tanaka dealer if you need assistance. WARNING For Tanaka heads, use only flexible, non-metallic line recommended by the manufacturer. Never use wire or wire ropes. They can break off and become a dangerous projectile. 3. Installation (Fig. 4) Insert the allen wrench (7) into the hole of the gear case in order to lock the drive shaft tube. Install cutting head on gear case of grass trimmers. The mounting nut is left-handthreaded. Turn clockwise to loosen/counterclockwise to tighten. 7 Fig. 6 Adjust the nylon line to the proper length of 4-11/32˝-5-1/2˝ (11-14 cm) before each operation. OPERATING PROCEDURES Fuel (Fig. 7) Fig. 4 4. Adjusting line length Set the engine speed as low as possible and tap the head on the ground. The nylon line will be drawn out about 1-3/16˝ (3 cm) with each tap. (Fig. 5) Fig. 7 WARNING ● The trimmer is equipped with a two-stroke engine. Always run the engine on fuel, which is mixed with oil. Provide good ventilation, when fueling or handling fuel. ● Fuel contains highly flammable and it is possible to get the serious personal injury when inhaling or spilling on your body. Always pay attention when handling fuel. Always have good ventilation when handling fuel inside building. 9