Tanaka TCG24ECPSL Manual - Page 15
For long-term storage, Maintenance schedule, Daily maintenance, Weekly maintenance, Monthly
View all Tanaka TCG24ECPSL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
English (6) Place the cover over the case so that the cap locking tabs (19) on the case meet the long holes (20) on the cover. Then push the case securely until it clicks into place. (Fig. 25) 20 19 Fig. 25 (7) The initial cutting line length should be approx. 4-11/32˝-5-1/2˝ (11-14 cm) and should be equal on both sides. (Fig. 26) Daily maintenance ○ Clean the exterior of the unit. ○ Check that the harness is undamaged. ○ Check the cutting attachment guard for damage or cracks. Change the guard in case of impacts or cracks. ○ Check that the cutting attachment is properly centred, sharp, and without cracks. An off-centre cutting attachment induces heavy vibrations that may damage the unit. ○ Check that the cutting attachment nut is sufficiently tightened. ○ Check that nuts and screws are sufficiently tightened. ○ Check that the unit is undamaged and free of defects. Weekly maintenance ○ Check the starter, especially the cord and return spring. ○ Clean the exterior of the spark plug. ○ Remove the spark plug and check the electrode gap. Adjust it to 0.024˝ (0.6 mm), or change the spark plug. ○ Check that the angle gear is filled with grease up to 3/4. ○ Clean the air filter. 4-11/32˝-5-1/2˝ (11-14 cm) 4-11/32˝-5-1/2˝ (11-14 cm) Monthly maintenance ○ Rinse the fuel tank with gasoline. ○ Clean the exterior of the carburetor and the space around it. ○ Clean the fan and the space around it. Fig. 26 For long-term storage Drain all fuel from the fuel tank. Start and let engine run until it stops. Repair any damage which has resulted from use. Clean the unit with a clean rag, or the use of high pressure air hose. Put a few drops of two-cycle engine oil into the cylinder through the spark plug hole, and spin the engine over several times to distribute oil. Cover the unit and store it in a dry area. Maintenance schedule Below you will find some general maintenance instructions. For further information please contact Tanaka dealer. 15