TP-Link ER7212PC ER7212PCUN V1 User Guide - Page 126

Chapter 3 Configure the Network with Omada SDN Controller 2. Enter a name to identify the VPN policy and select the purpose as Client-to-Site VPN. Refer to the following table to configure the required parameters and click Create. Name Enter a name to identify the VPN policy. Status Click the checkbox to enable the VPN policy. Purpose Select the purpose for the VPN as Client-to-Site VPN. VPN Type Select the VPN type as VPN Server - PPTP. MPPE Encryption Specify whether to enable MPPE (Microsoft Point-to-Point Encryption) for the tunnel. Encrypted: With Encrypted selected, the PPTP tunnel will be encrypted by MPPE. Unencrypted: With Unencrypted selected, the PPTP tunnel will be not encrypted by MPPE. Local Networks Select the networks on the local side of the VPN tunnel. The VPN policy will be only applied to the selected local networks. WAN Select the WAN port on which the PPTP VPN tunnel is established. Each WAN port supports only one PPTP VPN tunnel when the gateway works as a PPTP server. IP Pool Enter the IP address and subnet mask to decide the range of the VPN IP pool. The VPN server will assign IP address to the remote host when the tunnel is established. You can specify any reasonable IP address that will not cause overlap with the IP address of the LAN on the local peer router. 3. Add the VPN users account to validate remote hosts. To create VPN users, refer to 3. 7. 2 VPN User. 120