Smeg DOU330X1 Instruction Manual - Page 34

Use & Care Manual ENGLISH Solving Operational Problems Before calling for service, check the following to avoid unnecessary service charges. Oven Problem F03 or F04 Error appears in the display window. Problem Solving Steps A problem with latch mechanism occurred. Remove power and turn it back on again after a few seconds. The oven should run a latch auto-test. If condition persists, note the code number and call an authorized service. Other F__ Error appears in Remove power and turn it back on again after a few seconds. If condition persists, note the display window. the code number and call an authorized service. The oven display stays OFF Turn off power at the main power supply (fuse or breaker box). Turn breaker back on. If condition persists, call an authorized service center. Cooling fan continues to The fan turns off automatically when the electronic components have cooled sufficiently. run after oven is turned off Oven door is locked and Turn the oven off at the circuit breaker and wait a few seconds. Turn breaker back on. will not release, even after The oven should reset itself and will be operable. cooling Oven is not heating Check the circuit breaker or fuse box to your house. Make sure there is proper electrical power to the oven. Make sure the oven temperature has been selected. Oven is not cooking evenly Check oven calibration. Adjust calibration if necessary (see To Set Temperature, Page 14). Refer to cook charts for recommended rack position. Always reduce recipe temperature by 25°F (15°C) when baking with Convention Bake mode. Oven temperature is too The oven thermostat needs adjustment. See Calibrating Oven Temperature, Page 14. hot or too cold Oven light is not working Replace or reinsert the light bulb if loose or defective. See Page 32. Touching the bulb properly with fingers may cause the bulb to burn out. Oven light stays on Check for obstruction in oven door. Check to see if hinge is bent or door switch broken. Cannot remove lens cover There may be a soil build-up around the lens cover. Wipe lens cover area with a clean dry on light towel prior to attempting to remove the lens cover. Oven will not Self-Clean Allow the oven to cool before running Self-Clean. Always wipe out loose soils or heavy properly spill-over before running Self-Clean. If oven is badly soiled, set oven for a four-hour Self-Clean. See Preparing the Oven to Self-Clean, Page 28. Clock and timer are not Make sure there is proper electrical power to the oven. See the Clock and Timer sections working properly on Page 13. Excessive moisture When using Bake mode, preheat the oven first. Convection Bake and Convection Roast will eliminate any moisture in oven (this is one of the advantages of convection). Porcelain chips When oven racks are removed and replaced, always tilt racks upward and do not force them to avoid chipping the porcelain. Service Data Record For authorized service or parts information see paragraph "Warranty .." . The location of the serial tag on the product can be seen when the oven door is opened. It is located on the left side, centered vertically just inside the oven cavity. See Page 7. Now is a good time to write this information in the space below provided. Keep your invoice for warranty validation. Model Number Serial Number Date of Installation or Occupancy 34