Epson TM-T88IV TM-T88IV Technical Reference Guide - Page 55
Connecting the Cash Drawer, Connecting the Drawer Kick-out Cable
View all Epson TM-T88IV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Chapter 2 Setup Connecting the Cash Drawer Use the cash drawer handled by EPSON or your dealer. Connecting the Drawer Kick-out Cable • Specifications of drawers differ depending on makers or models. When you use a drawer other than specified, make sure its specification meets the following con- WARNING ditions. Otherwise, devices may be damaged. ∗ The load, such as a drawer kick-out solenoid, must be connected between pins 4 and 2 or pins 4 and 5 of the drawer kick-out connector. ∗ When the drawer open/close signal is used, a switch must be provided between drawer kick-out connector pins 3 and 6. ∗ The resistance of the load, such as a drawer kick-out solenoid, must be 24 Ω or more or the input current must be 1A or less. ∗ Be sure to use the 24V power output on drawer-kick out connector pin 4 for driving the 2 equipment. • Use a shield cable for the drawer connector cable. • Two driver transistors cannot be energized simultaneously. • Leave intervals longer than 4 times the drawer driving pulse when sending it continuously. • Be sure to use the printer power supply (connector pin 4) for the drawer power source. • Do not insert a telephone line into the drawer kick-out connector. Doing so may damage the telephone line or printer. Connect the connector of the drawer kick-out cable to the printer. 55