Epson LS100 Users Guide - Page 174

Displaying From a Mac Laptop If you see the "No Signal" message when you display from a Mac laptop, you need to set up the laptop for mirrored display. (See your laptop manual for details.) 1. Open the System Preferences utility and select Displays, Display, or Color LCD. 2. Click the Arrange or Arrangement tab. 3. Select the Mirror Displays checkbox. Parent topic: Solutions When "No Signal" Message Appears Solutions When "Not Supported" Message Appears If the "Not Supported" message appears, try the following solutions: • Make sure the input signal is supported by the projector. • Make sure the computer's display resolution does not exceed the projector's resolution and frequency limit. If necessary, select a different display resolution for your computer. (See your computer manual for details.) • As a test, try setting the computer's display resolution to the lowest possible setting, and then gradually increase it as necessary. Parent topic: Solving Image or Sound Problems Related references Input Signal Settings - Signal Menu Solutions When Only a Partial Image Appears If only a partial computer image appears, try the following solutions: • For VGA connections, press the Auto button on the remote control to optimize the image signal. • Make sure the Resolution setting in the Signal menu is set correctly for the input signal. • Try adjusting the image position using the Position menu setting. • Press the Aspect button on the remote control to select a different image aspect ratio. • If you zoomed into or out of the image using the E-Zoom buttons, press the Esc button until the projector returns to a full display. • Check your computer display settings to disable dual display and set the resolution within the projector's limits. (See your computer manual for details.) 174