Dell Latitude 5490 Owners Manual - Page 85
POST Behavior screen options
View all Dell Latitude 5490 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Option Description • Control WWAN Radio Default setting: The options are disabled. Wake on LAN/ WLAN Allows you to enable or disable the feature that powers on the computer from the Off state when triggered by a LAN signal. • Disabled • LAN Only • WLAN Only • LAN or WLAN Default setting: Disabled Block Sleep This option lets you block entering to sleep (S3 state) in operating system environment. Block Sleep (S3 state) Default setting: This option is disabled Peak Shift Advanced Battery Charge Configuration This option enables you to minimize the AC power consumption during the peak power times of day. After you enable this option, your system runs only in battery even if the AC is attached. This option enables you to maximize the battery health. By enabling this option, your system uses the standard charging algorithm and other techniques, during the non-work hours to improve the battery health. Disabled Default setting: Disabled Primary Battery Charge Configuration Allows you to select the charging mode for the battery. The options are: • Adaptive (default) • Standard - Fully charges your battery at a standard rate. • ExpressCharge - The battery charges over a shorter period of time using Dell's fast charging technology. This option is enabled by default. • Primarily AC use • Custom If Custom Charge is selected, you can also configure Custom Charge Start and Custom Charge Stop. NOTE: All charging mode may not be available for all the batteries. To enable this option, disable the Advanced Battery Charge Configuration option. Type-C Connector Power This option lets you set the maximum power that can be drawn from the Type-C connector. • 7.5 Watts (default) • 15 Watts POST Behavior screen options Option Adapter Warnings Description Allows you to enable or disable the system setup (BIOS) warning messages when you use certain power adapters. Default setting: Enable Adapter Warnings System setup options 85