DeLonghi ESAM6620 Owner Manual - Page 24

Problem, Possible Cause, Remedy

Page 24 highlights

PROBLEM The milk does not come out of the milk spout. (B5). POSSIBLE CAUSE REMEDY • The intake tube is not inserted or is • Insert the intake tube in the rubber inserted incorrectly. washer in the milk container lid (fig. 16). The milk is not well frothed. • The froth regulator is incorrectly adjusted. • Adjust following the instructions in the section on preparing drinks with milk. • The milk container lid is dirty. • Clean the milk container lid as described in the section "Cleaning the milk container". The milk contains bubbles or squirts out • The milk is not cold enough or is of the milk spout. not semi-skimmed. • You should ideally use skimmed or semi-skimmed milk at refrigerator temperature (about 5°C). If the result is still disappointing, try another brand of milk. • The froth regulator is incorrectly adjusted. • Adjust following the instructions in the section on preparing drinks with milk. • The milk container lid is dirty. • Clean the milk container lid as described in the section "Cleaning the milk container". The appliance does not come on. • It is not plugged into the mains socket. • Plug into the mains socket. • The main switch is not turned on. • Place the main switch on the back of the appliance in the I position (fig. 1). "Energy Saving" mode is enabled, but the cup warmer is hot • A number of drinks have been prepared in rapid succession. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25

22
PROBLEM
POSSIBLE CAUSE
REMEDY
The milk does not come out of the milk
spout. (B5).
The intake tube is not inserted or is
inserted incorrectly.
Insert the intake tube in the rubber
washer in the milk container lid
(fig. 16).
The milk is not well frothed.
The froth regulator is incorrectly
adjusted.
Adjust following the instructions
in the section on preparing drinks
with milk.
The milk container lid is dirty.
Clean the milk container lid as
described in the section “Cleaning
the milk container”.
The milk contains bubbles or squirts out
of the milk spout.
The milk is not cold enough or is
not semi-skimmed.
You should ideally use skimmed or
semi-skimmed milk at refrigerator
temperature (about 5°C).
If the
result is still disappointing, try
another brand of milk.
The froth regulator is incorrectly
adjusted.
Adjust following the instructions
in the section on preparing drinks
with milk.
The milk container lid is dirty.
Clean the milk container lid as
described in the section “Cleaning
the milk container”.
The appliance does not come on.
It is not plugged into the mains
socket.
Plug into the mains socket.
The main switch is not turned on.
Place the main switch on the back
of the appliance in the I position
(fig. 1).
“Energy Saving” mode is enabled, but
the cup warmer is hot
A number of drinks have been
prepared in rapid succession.