DeLonghi ESAM6620 Owner Manual - Page 20
Pdescale
View all DeLonghi ESAM6620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
it onto the internal support and pin at the bottom, then push the PUSH symbol fully in until it clicks into place. the dishwasher. Make sure there are no milk residues left inside the holes and the groove on the fine end of the froth regulator. 5. Check that the intake tube and spout are not clogged with milk residues. 6. Replace the froth regulator, milk spout and intake tube. 7. Replace the lid on the milk container, turning it anticlockwise to hook it in place. Please note: If the infuser is difficult to insert, you must first adapt it to the right dimensions by pressing it forcefully from the bottom and top as shown in the figure. 7. Once inserted, make sure the two red buttons have snapped out. 8. Replace the drip tray and grounds container. 9. Close the service door. Cleaning the milk container Clean the milk container regularly as described below: 1. Turn the milk container lid clockwise then remove it. 2. Remove the milk spout and intake tube. 3. Remove the froth regulator by pulling it outwards. 4. Wash all the components thoroughly with hot water and mild washing-up liquid. All components can be washed in a dishwasher, placing them in the top basket of Descale Descale the machine when the message "DESCALE!" flashes on the display. Important! Descaler contains acids which may irritate the skin and eyes. It is vital to respect the manufacturer's safety warnings given on the descaler pack and the warnings relating to the procedure to follow in the event of contact with the skin and eyes. Please note: Use De'Longhi descaler only. Under no circumstances should you use sulphamic or acetic based descalers. Their use invalidates the guarantee. Failure to descale the appliance as described also invalidates the guarantee. 1. Turn the machine on. 2. Enter the settings menu by pressing the P button. 3. Press the button (corresponding to the symbol flashing on the display) until the menu arrow is on "DESCALE NO". 4. Press the button (corresponding to the SET symbol flashing on the display) and "DESCALE YES" appears. Press OK to activate the function. 5. The message "ADD DESCALER" is displayed. 6. Before confirming, empty the water tank (A12). Pour the descaler diluted with water (respecting the proportions indicated on the descaler bottle) into the water tank. Place an empty container with a minimum capacity of 1.5 litres under the hot water spout. 18