DeLonghi ESAM6620 Owner Manual - Page 22

DISPLAYED MESSAGES MESSAGE FILL TANK GROUND TOO FINE ADJUST Grinder AND INSERT WATER SPOUT AND PRESS OK EMPTY GROUNDS CONTAINER INSERT GROUNDS CONTAINER ADD PRE-GROUND COFFEE FILL BEANS CONTAINER DESCALE MEANING WHAT TO DO • The water tank is empty or positioned incorrectly. • Fill the tank with water and/or insert it correctly, pushing it as far as it will go. • The grinding is too fine and the coffee is delivered too slowly. • Repeat coffee delivery and turn the grinding adjustment knob one click clockwise towards "7" while the coffee grinder is in operation. The effect is only visible after delivering two coffees. • The machine cannot make coffee as there is air in the hydraulic circuit. • Press the OK button to deliver water from the spout until it flows out normally. • The grounds container is full or • Empty the grounds container and more than three days have passed clean, then replace. Important: since you last made coffee (this when removing the drip tray, guarantees correct hygiene of the the grounds container MUST be machine). emptied, even if it is not completely full. If this is not done, when you make the next coffees, the grounds container may fill up more than expected and clog the machine. • After cleaning, the grounds container has not been replaced. • Open the service door and insert the grounds container. • With the function selected, pre- • Place pre-ground coffee in the ground coffee has not been poured funnel. into the funnel. • The funnel (A8) is blocked. • Empty the funnel with the help of a knife, as described in the section "Cleaning the pre-ground coffee funnel". • The coffee beans have run out. • Fill beans container • The pre-ground coffee funnel is clogged. • Empty the funnel with the help of a knife, as described in the section "Cleaning the pre-ground coffee funnel". • The machine must be descaled. • The descaling procedure described in the "Descale" section needs to be performed as soon as possible. CLOSE DOOR INSERT WATER SPOUT INSERT INFUSER ASSEMBLY reduce coffee amount INSERT MILK CONTAINER! • The service door is open • Close the service door. • The hot water spout is not inserted • Insert the hot water spout as far as or is inserted incorrectly. it will go. • The infuser has not been replaced • Insert the infuser as described in after cleaning. the section "Cleaning the infuser". • Too much coffee has been used. • Select a milder taste or reduce the quantity of pre-ground coffee, then make the coffee again. • The milk container is not inserted. • Insert the milk container as far as it will go. 20