2012 Yamaha Motorsports RS Vector Owners Manual - Page 96
2012 Yamaha Motorsports RS Vector Manual
Page 96 highlights
Periodic maintenance and adjustment Standard V-belt position: From 1.5 mm (0.06 in) above the edge of the secondary sheave assembly to 0.5 mm (0.02 in) below the edge 8. If the V-belt position is incorrect, adjust it by removing or adding a spacer on each V-belt position adjusting bolt. 1. V-belt 6. 7. Remove the V-belt from the secondary sheave assembly and primary sheave assembly. Temporarily install the new V-belt on the secondary sheave assembly only, and then measure the V-belt position. Do not force the V-belt between the sheaves; the secondary sliding and fixed sheaves must touch each other. 2 1 1. V-belt position adjusting bolt 2. Spacer V-belt position More than 1.5 mm (0.06 in) above the edge From 1.5 mm (0.06 in) above the edge to 0.5 mm (0.02 in) below the edge Adjustment Remove a spacer. Not necessary (it is correct). 1. Edge of the secondary sheave assembly 2. Standard V-belt position More than 0.5 mm (0.02 in) below the edge Add a spacer. 90