2012 Yamaha Motorsports RS Vector Owners Manual - Page 124
2012 Yamaha Motorsports RS Vector Manual
Page 124 highlights
Troubleshooting 4. Pull the red (+) connecting lead cover to expose the terminal through the slit in the cover, and then connect the red (+) jumper cable to the red (+) connecting lead. 8. 9. 10. 11. 12. 5. 6. 7. Connect the other end of the red (+) jumper cable to the positive (+) terminal of the booster battery. Connect the black (-) jumper cable to the negative (-) terminal of the booster battery. Pull the black (-) connecting lead cover to expose the terminal through the slit in the cover, and then connect the black (-) jumper cable to the black (-) connecting lead. 13. 14. Start the engine. Disconnect the black (-) jumper cable from the black (-) connecting lead, and then pull the cover completely over the lead terminal. Disconnect the black (-) jumper cable from the negative (-) terminal of the battery used to jump-start the engine. Disconnect the red (+) jumper cable from the positive (+) terminal of the battery used to jump-start the engine. Disconnect the red (+) jumper cable from the red (+) connecting lead, and then pull the cover completely over the lead terminal. Install the red (+) connecting lead into the lead holder. Install the right side cover and the shroud (RS90P / RS90PLT / RST90PGT), or close the shroud (RST90). TIP Make sure that both the red (+) connecting lead and the black (-) connecting lead are seated securely in the lead holders. Electric starter does not operate or operates slowly G G G Engine stop switch is pushed in: Pull it out. Faulty wire connections: Check connections or ask a Yamaha dealer to check. Discharged battery: Charge battery or see "Discharged battery" above. 118