2011 Polaris Cross Country Owners Manual - Page 41

Pre-Ride Inspections Turn the ignition key to the ON position and move the stop/run switch to RUN before performing the following electrical inspections. Return the ignition key to the OFF position after completing these inspections. If inspection of any electrical item reveals component failure, repair or replace the component before operating the motorcycle. Item Electrical Headlamp Taillight/Brakelight Switch to high beam. Verify that the high beam indicator comes on and that lamp brightness increases. Verify that the taillight and license plate light illuminate. Verify that the taillight lamps increase in brightness when the front brake lever is applied and also when the rear brake pedal is applied. Move the turn signal switch to the left. Verify that front and rear left turn signals flash, as well as the corresponding light on the indicator panel. Push the switch inward to cancel the signal. Verify that the signals and the indicator light stop flashing. Repeat the procedure for the right turn signals. Press the top of the hazard switch to turn the flashers on. Verify that all four turn signals flash, as well as the lamps on the indicator panel. Turn the flashers off. Verify that all signals and indicator lamps stop flashing. Press the horn button. Verify that the horn sounds loudly. Place the transmission in neutral. Verify that the neutral indicator lamp illuminates and that the letter "N" displays in the gear position display. Verify that the low oil pressure lamp illuminates. Start the engine and verify that the low oil pressure lamp goes off. Start the engine. Move the stop/run switch to the STOP position. Verify that the engine stops. Attempt to restart the engine to verify that the engine WILL NOT start. Check the oil level on the dipstick. View the fuel gauge or information bar. Inspect condition, pressure and tread depth. Inspect pedal and lever movement. Check front and rear brake fluid levels. Inspect hoses, connections, brake pads. Inspect hand grip and throttle freeplay. Check for leaks, debris and damage. Check for smooth operation. Check shock movement and air pressure, verify ground clearance. Check for wear, damage, proper deflection. Verify smooth operation, inspect pivot bolt, spring and pad. Inspect for loose, damaged or missing fasteners. Adjust for proper rear view. Inspection Procedure Turn Signals Emergency Flashers Horn Neutral Indicator Low Oil Pressure Indicator Engine Stop/Run Switch General Engine Oil Level Fuel Level Tires Brake Operation Brake Fluid Levels Brake Components Throttle Front Suspension Steering Rear Suspension Drive Belt Sidestand Fasteners Mirrors Clutch (Mechanical) Check lever operation and freeplay. 37