2011 Polaris Cross Country Owners Manual - Page 116

CB Radio / ICOM System ICOM System Press and release ICOM on the left control to activate the intercom system. When the intercom system is active, ICOM will display on the console screen. FM ICOM CB19 Driver ICOM Volume To change settings, enter the mode menu. Press TUNE (+) or TUNE (-) to adjust settings. + TUNE ICOM VOL 15 92.5 Tip: Intercom volume can also be adjusted with the hand control when the VOX circuit is open. VOX Break Setting The intercom is opened and closed using a voice-operated switch (VOX). The volume sensitivity level required to open the intercom can be adjusted using the VOX sensitivity setting. Press and hold ICOM on the upper left control to access the VOX sensitivity set screen. Push COM or ICOM to adjust the sensitivity setting. Tip: Lower settings require less volume to open the intercom. If wind or ambient vehicle noise trigger the VOX to open, set the VOX sensitivity to a higher level. Passenger ICOM Volume Press (+) or (-) on the headset control to raise or lower volume. Headset Receptacles The driver's headset receptacle is located on the left side of the motorcycle below the fuel tank. The passenger headset receptacle (if equipped) is located on the left side of the motorcycle on the forward side of the saddlebag. COM +/ICOM VOX 15 "VOX" will display on the console screen whenever the driver or passenger are communicating over the intercom system. FM VOX CB19 100.5 112