2011 Kawasaki Brute Force 650 4x4 Owners Manual - Page 171
2011 Kawasaki Brute Force 650 4x4 Manual
Page 171 highlights
MAINTENANCE AND ADJUSTMENT 169 charger will keep the battery fully charged un• The til you are ready to reinstall the battery in the vehicle (see Battery Installation). NOTICE Never remove the sealing strip, or the battery can be damaged. Do not install a conventional battery in this vehicle, or the electrical system cannot work properly. NOTE j A. B. C. D. Bolts Holder (+) Terminal (-) Terminal żIf you charge the sealed battery, never fail to observe the instructions shown on the label on the battery. WARNING HAZARD Handling battery parts that contain lead and lead compounds WHAT CAN HAPPEN Could cause health problem. HOW TO AVOID THE HAZARD Wash hands after handling battery. the cables from the battery, first from • Disconnect the (-) terminal and then the (+) terminal. the battery out of the case. • Remove Clean the using a solution of baking soda • and water.battery Be sure that the lead connections are • clean. Perform a visual inspection. Inspect for defective or cracked case and cover, and loose or damaged terminal posts or cables. Replace battery and/or cables immediately if any damage is found. Battery Removal & Inspection Battery Installation the seat. • Remove Loosen the bolts to remove the battery holder. • that the rubber dampers on the battery • Check holder and the battery case are properly in place.