Invacare R51 Owners Manual - Page 58
Battery Boxes
View all Invacare R51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
SECTION 12-BATTERIES CAUTION When connecting the battery cables to the battery(ies), the battery cable(s) MUST be connected to the battery terminal(s)/post(s) as shown in Detail "A" or Detail "B" of FIGURE 12.6 (depending on battery type), otherwise damage to the battery cable may result when installing battery terminal caps. 2. Connect battery cable(s) to battery(ies) terminal(s)/post(s) as shown in Detail "A" or Detail "B" of FIGURE 12.6, depending on battery type: A. NEGATIVE (-) BLACK battery cable to NEGATIVE (-) battery terminal/post. B. POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post. 3. Secure the battery cable(s)/ring terminal(s) to the battery terminal(s)/post(s), BLACK to NEGATIVE (-) and RED to POSITIVE (+), with the provided 1/4-20 x 7/8-inch hex flange screw and hex flange locknut as shown in Detail "A" or Detail "B" of FIGURE 12.6, depending on battery type. Securely tighten. 4. Verify all battery cable(s)/ring terminal(s) are correctly installed and securely tightened. 5. Slide terminal cap(s) down battery cable(s) and onto battery clamps (FIGURE 12.6). 6. Using the 11½-inch long tie-wrap, secure each terminal cap in place (Detail "C" of FIGURE 12.6). NOTE: It will be necessary to trim excess tie-wrap in order to install the battery box top(s). 7. Install the battery box top(s). 8. Install the battery box(es) into the wheelchair. Refer to Installing/Removing the Battery Boxes on page 53. NOTE: New battery(ies) MUST be fully charged BEFORE using, otherwise the life of the battery(ies) will be reduced. 9. If necessary, charge the battery(ies). Refer to When to Charge Batteries on page 65. R51™and R51LXP 58 Part No. 1106645