Invacare R51 Owners Manual - Page 38
FRONT RIGGINGS, Adjusting/Replacing Telescoping Front Rigging Support
View all Invacare R51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
SECTION 6-FRONT RIGGINGS 4. Perform one of the following: • Adjusting: NOTE: Telescoping front rigging supports may be extended up to 2-inches from the wheelchair frame in 1-inch increments. This adjustment does not effect seat depth. i. Position the telescoping front rigging support to the desired depth. • Replacing: i. Remove the existing telescoping front rigging support from the wheelchair frame. ii. Insert the new telescoping front rigging support into the wheelchair frame. iii. Position the telescoping front rigging support to the desired depth. NOTE: The footplate will be on the inside of the wheelchair when locked in place. 5. Using the front and rear socket bolts and two locknuts, secure the telescoping front rigging support to the wheelchair frame as shown in FIGURE 6.7. 6. Using the long socket bolt and locknut, secure the H-block and spacer to the wheelchair frame and the telescoping front rigging support as shown in FIGURE 6.7. 7. Snap crossbraces into H-blocks. Wiggle crossbraces to make sure they are secured in the H-blocks. 8. If necessary, repeat STEPS 1-8 on remaining telescoping front rigging support. H-Block Wheelchair Frame Locknuts Do Not Use With Front Socket Bolt Rear Socket Bolt Long Socket Bolt Front Socket Bolt Spacer 2-inch 1-inch 0-inch Telescoping Front Rigging Support Front Socket Bolt Positions (Depth) FIGURE 6.7 Adjusting/Replacing Telescoping Front Rigging Support R51™and R51LXP 38 Part No. 1106645