InSinkErator Model WX-300 Owners Manual - Page 7

InSinkErator Mounting Assemblies STANDARD MOUNTING ASSEMBLY 1. Place mounting flange (1) over the existing collar adaptor connection lip or sink bowl flange (this may require some force). 2. Push the mounting flange up out of the way and fit the groove in the mounting gasket (2) onto the connection lip. Make sure the gasket is fully seated on the flange. 3. Push the mounting flange down over the mounting gasket, fitting the threaded mounting flange fasteners into the recesses in the top of the mounting gasket. 4. From the bottom, insert two screws through opposite sides of the flat gasket (3) and mounting flange, into the threaded fasteners in the existing flange. The flat gasket is used only in the #6 mounting assembly. The screws should protrude about 1/4 inch below the mounting gasket. 5. Position the disposer beneath the mounting gasket and raise it to engage the two protruding screws in the disposer body flange keyhole slots. Secure the remaining screws and position the disposer correctly for the plumbing connections. If disposer legs are included, adjust the legs to support the disposer. #6 Collar Adaptor (1) Mounting Flange (2) Mounting Gasket (3) Flat Gasket Disposer Body Flange 1/4" Screw #7 Collar Adaptor (1) Mounting Flange (2) Mounting Gasket Disposer Body Flange 1/4" Screw Figure 6. #6 Mounting Assembly Figure 7. #7 or Sink Bowl Mounting Assembly SPECIAL INSINKERATOR MOUNTING ASSEMBLIES When installing an InSinkErator Foodservice disposer to a non-InSinkErator sink bowl, a special mounting adaptor kit is required. The special mountings are described in the Mounting Adaptor Selection Guide (for more information, call 1-800-845-8345 or go to www.insinkerator.com). Figures 8-10 show examples of non-InSinkErator style sinks. (Mounting instructions are included in each special mounting adaptor kit.) Figure 8. Outward Flange Figure 9. Inward Flange Figure 10. Straight Flange 8