InSinkErator Model WX-300 Owners Manual - Page 10
Plumbing Connections
View all InSinkErator Model WX-300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Plumbing Connections PROPERTY DAMAGE Water connections must comply with all local plumbing codes. WASTE INLET LINE Connect the disposer outlet flange as close as possible and with as few as possible 90° elbows to the Waste Xpress inlet. NOTE: The maximum allowable distance between the disposer outlet flange and the Waste Xpress inlet is 10 feet with a maximum of four (4) 90° elbows. Figure 15. 1. Connect the disposer outlet to the Waste Xpress inlet using 2" NPT plumbing. 3 HP will require 3" outlet adapter. The run between the disposer and Waste Xpress should have 1/4" slope per foot and must comply with all local codes. NOTE: All horizontal runs should be as short as possible (not to exceed 10 ft.), with an approximate fall of 1/4" per foot. TO REVERSE AUGER SCREEN: A. Holding both handles remove discharge chute of the Waste Xpress by tilting it upward (see Figure 13). B. Remove auger-bearing bracket by sliding the two captive fasteners inward and then pull bracket upward (see Figure 14). C. Lift auger and screen up and then out (see Figure 14). D. Remove auger from screen by lifting up (see Figure 15). Inlet Figure 16. E. Remove four nuts and washers holding the top portion of the auger screen to the bottom portion (see Figure 16). F. Rotate bottom portion of the auger screen 180° and secure to top portion with four nuts and washers (see Figure 17). Figure 17. TO CHANGE WASTE INLET SIDE ON WASTE XPRESS: A. Remove four screws holding inlet fitting and gasket in position (see Figure 18). B. Remove four screws holding the cap and gasket in position (see Figure 18). C. Install gaskets, cap and inlet fitting on reverse side and secure with appropriate screws. Waste Outlet Figure 18. 11 Nuts & Washer (4) Auger Screen Waste Inlet