InSinkErator Model WX-300 Owners Manual - Page 19

Troubleshooting DISPOSER TROUBLESHOOTING PROBLEM Disposer motor will not start and water does not flow. CAUSE • No incoming line power • Line disconnect switch is not ON SOLUTION • Turn line power on. • Turn line disconnect to ON position. • Line disconnect switch has been reactivated and 30-second delay has not yet expired. • Wait 30 seconds and try starting again. • Control circuit fuse FNA2 is blown. • Replace fuse. Disposer does not reverse direction. • Control center has been reactivated • Wait until post-flush is complete and before post-flush delay has expired. try again. Disposer motor stops while grinding • Control center wired for but water continues to flow. automatic shut-off. • Press start button. If disposer runs for 10 minutes then shuts off, the automatic shutoff is active. If the manual setting is desired, change indicated in the feature section. • Disposer is jammed. • Press stop button and follow directions for dejamming in disposer installation manual. • Disposer motor overload protector has tripped. • Press stop button. Locate red reset button on front of disposer electrical cover. Press to reset. If motor had been running, wait five minutes for the motor and overload to cool down. Disposer will not start but water flows. • Overload protector on the disposer may have tripped. • Press stop button. Locate red reset button on front of disposer electrical cover. Press to reset. If motor had been running, wait five minutes for the motor and overload to cool down. • Disposer is jammed • Press stop button and follow directions for dejamming that were supplied with the disposer. Water flows constantly before start • Water solenoid valve is button is pushed. installed backward. • Water flow should be in the direction of the arrow on valve. Overload trips frequently. • Disposer overloaded. • Do not overload disposer with excess amounts of garbage and water. 20