HP XP P9500 HP StorageWorks P9000 Remote Web Console Messages (AV400-96375, Ma - Page 58
HP XP P9500 Manual
View all HP XP P9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Table 25 Error codes (part code 1005) (continued) Part Code 1005 Error Number 1135 1005 1138 1005 1140 1005 1170 1005 1174 1005 1005 1005 1177 1178 1180 1005 1181 1005 1194 1005 1199 1005 1350 1005 1352 1005 1353 1005 1354 1005 1355 Error Message Recommended Action Severity Level When setting the port information (Fibre Check the setting(s), then retry the W Address/Fibre Topology/Channel operation. Speed), multiple change instructions are set to the same port. The same setting is specified at LUNM operation. The configuration information has been W changed already. Check the settings, and request the configuration information setting again. Because the Port Group setting is done, Release the Port Group setting. W it is impossible to change. The volume cannot be configured as a Correct settings, then retry. W command device because the volume does not have Read/Write attribute. The specified host ID is already Correct the settings, then retry. W registered. The specified host is already registered. Correct the settings, then retry. W An incorrect host name was specified. Correct the settings, then retry. W An error occurred during SVP processing. If this problem persists, please contact E HP Technical Support. The specified path cannot be added, Correct the specification, then retry the W because the volume is used by a Remote operation. Copy pair. No information can be changed about Correct the settings, then retry. W this external port because the port has an external volume. The path cannot be set to the specified Check the setting. W volume because the volume is not an open-systems volume. You could not add the path to the initiator or external port. To add a path, change the attribute of W the specified port to Target or RCU Target. Logical paths remain on the Fibre-MCU Since the port you are trying to set is for W port. This operation may cause a fatal Remote Copy, you must delete the logical damage to the logical paths. Please stop path, then retry the port setting. this operation. If you want to continue this operation, please remove the logical paths from the MCU port first. S-VOLs remain on the Fibre-RCU port. This operation may cause a fatal damage to S-VOLs. Please stop this operation. If you want to continue this operation, please remove the S-VOLs from the RCU port first. Since the port you are trying to set is for W Remote Copy, you must delete the S-VOL logical path that is set to RCU Target, then retry the port setting. You could not register the WWN to the To register the WWN, change the W initiator or external port. attribute of the specified port to Target or RCU Target. You could not change the host mode of To change the host mode, change the W the host group that you connected to the attribute of the specified port to Target initiator or external port. or RCU Target. 58 Message (part code group 1nnn)