HP XP P9500 HP StorageWorks P9000 Remote Web Console Messages (AV400-96375, Ma - Page 255
HP XP P9500 Manual
View all HP XP P9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 255 highlights
Table 62 Error codes (part code 7105) (continued) Part Code 7105 7105 7105 7105 7105 7105 7105 7105 7105 7105 7105 7105 Error Number 8539 8540 8541 8542 8543 8544 8545 8546 8547 8548 8549 8550 Error Message Recommended Action Severity Level There is insufficient shared memory to There is insufficient shared memory in E create 4096 pairs. DKC. Please contact HP Technical Support. There is sufficient shared memory to Please contact HP Technical Support. E create 4096 pairs, but initial subsystem setup is required before creating pairs. There is sufficient shared memory to Close the message box. i create 4096 pairs, and the initial subsystem setup is complete. Failed to complete the initial shared memory setup. Please contact HP Technical Support. E The shared memory size is different. Please contact HP Technical Support. E 16 Mbytes of shared memory is Check the contents, and retry. W available. A power supply failure is detected. Please contact HP Technical Support. E The command was rejected. The PS OFF Retry the operation with power ON. W is in progress. A data transfer failure is detected (CHA). Please contact HP Technical Support. E A data transfer failure is detected (DKA). Please contact HP Technical Support. E The S-VOL is not implemented. You cannot execute the operation for the W volume which is not implemented. The command has been rejected, because the specified S-VOL is blocked or used as a system disk. • Restore the blocked volume, then retry E the operation. • The system disk cannot be specified as an S-VOL. Specify another volume. 7105 8551 7105 8552 7105 8553 7105 8554 The S-VOL is being formatted. Wait until the volume is formatted, and W retry the operation. This volume cannot be specified as an As the S-VOL, specify a volume that is W S-VOL because it is used as a command not used as a command device. device. The T-VOL is not implemented. You cannot execute the operation for the W volume which is not implemented. The command has been rejected, because the specified T-VOL is blocked or used as a system disk. • Restore the blocked volume, then retry W the operation. • The system disk cannot be specified as a T-VOL. Specify another volume. 7105 8555 7105 8556 7105 8557 The T-VOL is being formatted. Wait until the volume is formatted, and W retry the operation. This volume cannot be specified as an Release the command device, then retry W T-VOL because it is used as a command the operation. device. The volume is not implemented. You cannot execute the operation for the W volume which is not implemented. Part code 7105 255