HP XP P9500 HP StorageWorks P9000 Remote Web Console Messages (AV400-96375, Ma - Page 273

Table 65 Error codes (part code 8105) (continued) Part Code 8105 8105 8105 8105 8105 8105 8105 8105 8105 8105 8105 8105 8105 Error Number 1007 1009 1010 1018 1022 1023 1024 1025 1059 1061 1063 1064 1065 Error Message Recommended Action Severity Level Failed to remove the path. The specified Check the setting. W path is the last path of the volumes used for Remote Copy, Business Copy, Auto LUN, or Snapshot. The emulation type of the volumes is not The configuration information has been W for open systems, or the volumes are not changed already. Check the settings, mounted. and request the configuration information setting again. An error occurred during SVP processing. If this problem persists, please contact W HP Technical Support. The specified port does not exist. Or the The configuration information has been W specified port type is not Fibre port. changed already. Check the settings, and request the configuration information setting again. Invalid host mode. The configuration information has been W changed already. Check the settings, and request the configuration information setting again. The specified fiber address is wrong. Correct the specified content, and issue W the request again. (Currently, Bad Value Send report in Set Response.) Invalid Fibre topology information. The configuration information has been W changed already. Check the settings, and request the configuration information setting again. The specified LU path does not exist. The configuration information has been W changed already. Check the settings, and request the configuration information setting again LUN security setting has been made to a non-Fibre port. LUN security is a function of LUN Manager. Check the specified contents, then retry W the operation. Security Switch Off operation and path adding operation cannot be performed simultaneously. You are trying to perform LUN Security W operation for a port where LUN Security function is invalid. The error does not occur normally because it cannot be modified in the window. In the unlikely event that this error occurs, please contact HP Technical Support. The specified WWN is already in use. Check the specified contents, then retry W the operation. You are trying to register the same WWN that is already registered. The configuration information has been W changed already. Check the settings, and request the configuration information setting again. The specified host name or the host Correct the specified contents, and W group name is already registered. (The request the setting of the configuration host name and the host group name information again. cannot be the same.) Part code 8105 273