Epson SureColor F10070 Users Guide - Page 70
Important, holder may move during printing. This could
View all Epson SureColor F10070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
SC-F10000 Series User's Guide Basic Operations J While lifting the right lift lever, firmly insert the media holder onto the roll core of the media. L While pressing from the top of the media holder, tighten the fixing screw until it no longer turns. Tighten it so the media holder does not move. Note: If the roll of media has an outer diameter that is less than 140 mm, the roll core will not reach the media holder when raised using the lift lever. Raise it with your hands, and insert the roll core into the media holder. K To ensure that the media holder is sufficiently inserted into the roll core, push the top of the media holder towards the end of the roll two times. c Important: If the media holder screw is loose, the media holder may move during printing. This could cause stripes and unevenness in the print results. M Rotate the handle until part A in the illustration below is fully inserted. c Important: If the media holder is inserted into the roll core insufficiently, media is not fed correctly during printing because of slippage between the media holder and roll core. This may cause banding in the print results. c Important: Once part A is hidden, do not turn the handle any further. Failure to observe this precaution could damage the media holder. If part A is still visible even after the handle has been turned fully, rewind the handle. Loosen the media holder screw on the right side, and then restart from Step 5. 70