Dell Vostro 5471 Ownerss Manual - Page 30

Installing touchpad, Display assembly, Removing display assembly

Get Dell Vostro 5471 PDF manuals and user guides View all Dell Vostro 5471 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Installing touchpad 1. Replace the three screws to secure the touchpad support bracket to the system. 2. Connect the touchpad cable to the connector in the system. 3. Replace the four screws to secure the touchpad to the system. 4. Install the: a) hard drive b) battery c) base cover 5. Follow the procedure in After working inside your computer. Display assembly Removing display assembly 1. Follow the procedure in Before working inside your computer. 2. Remove the: a) base cover b) WLAN card 3. To remove the display assembly: a) Disconnect the eDP cable from the connector in the system board [1]. b) Remove the five M2.5 x 6 screws [2] that secure the hinge bracket to the system and lift the display assembly. 30 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
Installing touchpad
1.
Replace the three screws to secure the touchpad support bracket to the system.
2.
Connect the touchpad cable to the connector in the system.
3.
Replace the four screws to secure the touchpad to the system.
4.
Install the:
a)
hard drive
b)
battery
c)
base cover
5.
Follow the procedure in
After working inside your computer
.
Display assembly
Removing display assembly
1.
Follow the procedure in
Before working inside your computer
.
2.
Remove the:
a)
base cover
b)
WLAN card
3.
To remove the display assembly:
a)
Disconnect the eDP cable from the connector in the system board [1].
b)
Remove the five M2.5 x 6 screws [2] that secure the hinge bracket to the system and lift the display assembly.
30
Removing and installing components