2012 Yamaha Motorsports Apex SE Owners Manual - Page 61
2012 Yamaha Motorsports Apex SE Manual
Page 61 highlights
Periodic maintenance and adjustment 7. 8. Tighten the locknut. Install the headlight unit, making sure to fit the slots on its bottom over the projections on its stay. ESU11863 Checking the throttle override system (T.O.R.S.) EWS00352 WARNING When checking the T.O.R.S., take precautions to avoid snowmobile movement which could cause an accident: G Make sure that the throttle lever moves smoothly with the engine off before checking the T.O.R.S. G Make sure that the parking brake is applied. G Do not rev the engine to the point that the clutch engages. 1 2 1. Slot 2. Projection 9. Fit the weatherstrip on the headlight unit into the recess in the top of the air filter case cover. 1 Check the T.O.R.S. for proper operation. 1. Start the engine. 1. Weatherstrip TIP Refer to the "Starting the engine" section on page 38. 2. Hold the pivot point of the throttle lever away from the throttle switch by putting your thumb (above) and forefinger (below) between the throttle lever pivot and the engine stop switch housing. While holding the pivot point as described above, squeeze the throttle lever gradually. 10. Install the headlight unit bolts, and then tighten them to the specified torque. Headlight unit bolt tightening torque: 3.0 Nm (0.30 m·kgf, 2.2 ft·lbf) 11. Install the top cover, the left and right side covers, and the shroud. 55