2012 Yamaha Motorsports Apex SE Owners Manual - Page 20
2012 Yamaha Motorsports Apex SE Manual
Page 20 highlights
Control functions change tripmeter and "OIL" flash alternately in the odometer display, and the tripmeter starts counting the distance traveled from that point. When this occurs, change the engine oil as soon as possible. (See page 57 for the oil change procedure.) E LO If the engine oil is changed before the oil change tripmeter appears in the display (i.e., before the periodic oil change interval has been reached), the tripmeter must be reset after the oil change for the next periodic oil change to be indicated at the correct time. In that case, reset the oil change tripmeter as follows. To reset the oil change tripmeter (when the engine oil was changed before the oil change tripmeter appeared) 1. Push the "SELECT" button until "ODO" is displayed, and then push the "RESET" button for at least 1 second. The distance traveled since the last oil change and "OIL" will flash alternately in the odometer display. 2. Push the "RESET" button for approximately 3 seconds. "00000" and "OIL" will flash alternately in the odometer display 3 times, and then the display will return to the previous display mode. TIP G G The oil change tripmeter will flash only when the snowmobile is stopped. To return to the previous display mode, push the "SELECT" button. To display the oil change tripmeter again, turn the key to the off position, then back to the on position. Clock To set the clock 1. Push the "SELECT" button and "RESET" button simultaneously until the hour digits start flashing. After changing the engine oil, reset the oil change tripmeter as follows. To reset the oil change tripmeter (when the engine oil was changed after the oil change tripmeter appeared) 1. To display the oil change tripmeter, turn the key to the on position. 2. Push the "RESET" button for at least 1 second while the oil change tripmeter and "OIL" are flashing alternately in the odometer display. The distance traveled since the last oil change and "OIL" will flash alternately in the odometer display. 3. Push the "RESET" button for approximately 3 seconds. "00000" and "OIL" will flash alternately in the odometer display 3 times, and then the display will return to the previous display mode. 1 2 3 1. "SELECT" button 2. "RESET" button 3. Clock 14