2012 Yamaha Motorsports Apex SE Owners Manual - Page 21
2012 Yamaha Motorsports Apex SE Manual
Page 21 highlights
Control functions 2. Push the "RESET" button to change the hour setting, and then push the "SELECT" button. The minute digits will start flashing. Push the "RESET" button to change the minute setting, and then push the "SELECT" button. The clock starts when the "SELECT" button is released. ESU10411 High beam indicator light " " 3. The high beam indicator light comes on when the high beams of the headlights are switched on. (See page 20 for headlight beam switch operation.) TIP The clock must be set again when the battery is disconnected. Display brightness control This function allows you to adjust the brightness of the meter display to suit the outdoor lighting conditions. To adjust the display brightness 1. Turn the key to the off position. 2. Push and hold down the "SELECT" button. 1. High beam indicator light " ESU10473 " Low coolant temperature indicator light " " The low coolant temperature indicator light comes on when the coolant temperature is low and informs the rider that the snowmobile should be warmed up. After the engine is started, warm it up until the indicator light goes off. The snowmobile can be operated normally after the indicator light goes off. 1 2 3 1. "SELECT" button 2. "RESET" button 3. Display brightness level 3. 4. Turn the key to the on position, and then, after 5 seconds, release the "SELECT" button. Push the "RESET" button to select the desired display brightness level, and then push the "SELECT" button. The normal display returns when the "SELECT" button is released. 1. Low coolant temperature indicator light " " 15